Industrial products & aerospace components

Certificate Number 13609
ISO 9001

# Useful Information

## Other useful information

To find the circumference of a circle, multiply the diameter

by 3.14.

To find the diameter of a circle, multiply the circumference

by .318.

To find the area of a circle, multiply the square of the diameter

by .785.

The radius of a circle x 6.283185 = the circumference.

The square of the circumference of a circle x .7958 = the area.

Half the circumference of a circle x half its diameter = the area.

The circumference of a circle x .159155 = the radius.

The square root of the area of a circle x .56419 = the radius.

The square root of the area of a circle x 1.12838 = the diameter.

To find the diameter of a circle equal in area to a given square,

multiply a side of the square by 1.12838.

To find the side of a square equal in area to a given circle, multiply the diameter by 8862.

To find the side of a square inscribed in a circle, multiply the diameter by .7071.

To find the area of the surface of a ball (sphere), multiply the square of the diameter by 3.1416.

To find the volume of a ball (sphere), multiply the cube of the diameter by .5236.

Doubling the diameter of a pipe increase its capacity four times.

To find the pressure in pounds per square inch at the base of a column of water, multiply

the height of the column in feet by .433.

A gallon of water (U.S. Standard) weights 8.336 pounds and contains 231 cubic inches.

A cubic foot of water contains 7 ½ gallons, 1728 cubic inches and weighs 62.425 pounds at a

## Bearing terms

A.B.E.C. 1-3-5-7-9: Annular Bearing Engineering Committee grades concern precision tolerances and geometry of bearings. Higher number indicates higher precision.

A.F.B.M.A.: The Anti-Friction Bearing Manufacturers Association. Incorporated. They have set up standards for the bearing industry.

Adapter: An accessory for holding bearing to shaft. Standard taper is 1” on the diameter for each 12” length.

Average life: Five times minimum life.

B-10 Life: Minimum life that is expected of 90% of a group of bearings under identical operating conditions.

Boundary Dimensions: Dimensions for bore, outside diameter, and width.

Brinell: True_Identations in the races or on rolling elements caused by sharp blows (metal flow).

False – Wearing away of metal in raceways. It is caused by rolling elements – sliding back and forth on race while bearing is stationary. Vibration causes this sliding movement.

Cage: A ring with the necessary number of pockets to equally space rolling elements. Also called Separator-Retainer and Spacer.

Clearance: Radial clearance – The amount of movement of the outer race at right angles to the shaft axis when the inner is clamped. Also called Internal Radial Clearance – Internal Clearance and Diametrical Clearance.

Axis: Clearance-Total movement parallel to bearing axis when an axial load is applied in first one direction and then the other. Also called End Shake and Axial Play.

Conrad: Standard single row deep groove ball bearing. No filling slots and no counterbore.

Contact Seal: A closure that connects inner ring and outer ring with rubbing contact.

Counterbore Assembly: Portion of one race shoulder turned and ground away to facilitate assembly with a greater number of balls.

Cone: Tapered bearing inner ring.

Cup: Tapered bearing outer ring.

Super Precision Bearings: Bearings with faces ground in such a way that they can be matched with one or more mating bearings.

Floating Bearing: A bearing mounted to move freely axially either in housing or on the shaft.

Land: Commonly called the O.D. on inner and the I.D of outer.